The performance and use function of the miniature linear guide are basically the same as those of the imported linear guide. The matters needing attention during installation are as follows:
(1) Never remove the slider during installation. If there is no professional guidance, it is easy to affect the subsequent use of the slider.
(2) In the case of vertical installation, pay attention to the position of the slider. If you lose it accidentally, please remember to contact the production company in time.
(3) If you want to extend the service life of the miniature linear guide, it must be used at a suitable temperature. If it exceeds 80 degrees, you should not consider it. Analysis of the installation process of miniature linear guides In the early stages of industrial production, purchasing and installing equipment is an important step. Generally speaking, companies will consider the cost of choosing equipment. Basically, they will purchase appropriate production equipment to meet the cost-effectiveness. Installing production equipment quickly and accurately will save a lot of preparation time. Take the most popular miniature linear guide as an example. Due to the wide range of use, installation has become a common step. The first step of installing the miniature linear guide is to place the guide on the mounting surface. The reference hole and the threaded hole should be aligned at this time; the second step is to tighten it. When the two overlap, it is very simple. If there is an inappropriate need to use a taper Shape modification threaded holes, and then tighten all screws;
(4) The third part is to install auxiliary rails.
(5) After installation, a thorough and detailed inspection should be carried out to ensure that the accuracy of the installation is not a problem. Generally, optical instruments are used to check the accuracy of the installation. After passing, the dustproof hole can be fixed and put into use. If they are not qualified, the installation steps should be checked again to ensure that they can be used normally and will not damage the accuracy.
